CPSI Specific Equipment Standards for Swings and Slides 4

Question 1

According to ASTM F1487, what is the minimum overhead clearance required above the highest designated play surface of a swing structure?

Accepted Answer

9 feet (2.74 m)

Answer

ASTM F1487 requires a minimum of 9 feet (2.74 m) of overhead clearance above the highest designated play surface on swing structures.

Question 2

A 'tire swing' with a single-point suspension must have a use zone radius measured from what point?

Accepted Answer

The center of the swing pivot point

Answer

For single-point suspension tire swings, the use zone radius is measured from the center of the pivot point, extending at least 6 feet in all directions plus the length of the pendulum.

Question 3

Which condition on a slide chute surface requires immediate removal from service under CPSI guidelines?

Accepted Answer

A crack or perforation in the sliding surface

Answer

Any crack or perforation in a slide chute surface is a serious entrapment and injury hazard that requires immediate removal from service.

Question 4

What is the maximum allowable gap between the slide's exit edge and the ground for a slide intended for children under 5?

Accepted Answer

11 inches (27.9 cm)

Answer

For slides intended for children under 5, the exit edge must be no more than 11 inches (27.9 cm) above the protective surfacing.

Question 5

On a belt swing intended for school-age children, the minimum seat width specified by ASTM F1487 is:

Accepted Answer

8 inches (20.3 cm)

Answer

ASTM F1487 specifies that belt swing seats for school-age children must be at least 8 inches (20.3 cm) wide.

CPSI - Certified Playground Safety Inspector Practice Test

CPSI - Certified Playground Safety Inspector Practice Test

CPSI Specific Equipment Standards for Swings and Slides 4