CPSI Common Playground Hazards 5

Question 1

Which of the following is an example of a 'tripping hazard' specific to playground use zones?

Accepted Answer

An exposed concrete footing near the play structure

Answer

Exposed footings and anchors that protrude from the ground in or near use zones are classic tripping hazards for running children.

Question 2

A CPSI evaluates a composite play structure and finds a broken plastic component with a sharp, jagged edge. This hazard is categorized as a:

Accepted Answer

Laceration hazard

Answer

Broken components with sharp or jagged edges present a laceration hazard, capable of cutting a child's skin on contact.

Question 3

Under CPSC guidelines, what is the minimum fall zone (use zone) width that should extend from the perimeter of a structure with a maximum fall height of 8 feet?

Accepted Answer

6 feet

Answer

CPSC guidelines require a minimum use zone of 6 feet in all directions from the perimeter of most playground equipment.

Question 4

A child's finger becomes trapped in a small hole in a plastic deck panel. What type of hazard does this represent?

Accepted Answer

Finger entrapment hazard

Answer

Small openings that can trap fingers or toes, preventing them from being withdrawn, are classified as finger or toe entrapment hazards.

Question 5

A CPSI notices a broken bottle near a playground. Beyond the obvious cut hazard, what is the correct CPSI protocol?

Accepted Answer

Remove it immediately if safely possible and document the finding

Answer

CPSIs should remove immediate hazardous debris if safely possible, then document the finding to address the underlying maintenance issue.

CPSI - Certified Playground Safety Inspector Practice Test

CPSI - Certified Playground Safety Inspector Practice Test

CPSI Common Playground Hazards 5