Practice Test GeeksCPSI - Certified Playground Safety Inspector Practice Test
← All CPSI Flashcard Decks

Protective Surfacing Requirements Flashcards

7 cards from real CPSI practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Protective Surfacing Requirements flashcards as text

  1. When determining the required depth of loose-fill surfacing, which factor is MOST critical according to ASTM F1292?

    Answer: The critical fall height (CFH) of the equipment

    ASTM F1292 requires that loose-fill surfacing depth be sufficient to achieve a Head Injury Criterion (HIC) below 1000 at the equipment's critical fall height.

  2. A playground uses 12 inches of engineered wood fiber (EWF). After 6 months of use, an inspector finds compaction has reduced depth to 6 inches in high-use zones. What is the BEST corrective action?

    Answer: Redistribute and replenish EWF to restore the required depth

    Compacted or displaced loose-fill surfacing must be raked, redistributed, and replenished to restore the manufacturer-recommended and ASTM-compliant depth.

  3. Under CPSC guidelines, what is the minimum required depth of pea gravel for a piece of equipment with a critical fall height of 7 feet?

    Answer: 12 inches

    CPSC guidelines indicate that pea gravel requires 12 inches of depth to provide adequate protection at a critical fall height of 7 feet.

  4. Which of the following unitary surfacing materials is tested using ASTM F1292 to confirm its impact attenuation performance?

    Answer: Poured-in-place rubber

    Poured-in-place rubber is a unitary surface system tested per ASTM F1292 for impact attenuation performance at specified fall heights.

  5. A school is installing a new playground with equipment reaching 8 feet in height. Which surfacing option would be LEAST appropriate based on CPSC guidelines?

    Answer: Packed dirt

    Packed dirt does not provide adequate impact attenuation and is not an acceptable protective surfacing material under CPSC guidelines.

  6. What is the primary purpose of the 'use zone' (fall zone) around playground equipment?

    Answer: To provide an area of protective surfacing where a child might fall

    The use zone is the area around playground equipment that must be covered with protective surfacing because a child could land there if they fall.

  7. According to CPSC guidelines, what is the minimum use zone extension beyond the perimeter of stationary equipment (excluding swings and slides)?

    Answer: 6 feet

    CPSC guidelines require a minimum 6-foot use zone extending in all directions from stationary playground equipment.