Practice Test GeeksCPSI - Certified Playground Safety Inspector Practice Test
← All CPSI Flashcard Decks

Layout and Site Design Requirements (Use Zones) Questions and Answers Flashcards

7 cards from real CPSI practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Layout and Site Design Requirements (Use Zones) Questions and Answers flashcards as text

  1. For a single-axis swing with a pivot point height of 10 feet, what is the minimum use zone distance required in front of the swing?

    Answer: 20 feet

    For swings, the use zone extends a distance of 2 times the pivot height in both the front and rear directions, so 10 ft × 2 = 20 ft.

  2. Under ASTM F1487, may the use zones of two adjacent pieces of playground equipment overlap?

    Answer: No, use zones must never overlap

    Use zones of adjacent equipment must not overlap, ensuring children exiting one piece do not enter the path of children using another.

  3. What is the minimum use zone required around the perimeter of a merry-go-round?

    Answer: 6 feet

    ASTM F1487 requires a minimum 6-foot use zone extending beyond the perimeter of a merry-go-round in all directions.

  4. A spring rocker designed for one child is installed on a playground. What is the minimum use zone required on each side?

    Answer: 6 feet

    Spring rockers require a minimum 6-foot use zone on all sides, consistent with the standard clearance for most non-swinging equipment.

  5. When a composite play structure includes a slide, how is the use zone at the slide exit determined?

    Answer: A separate 6-foot use zone from the end of the slide exit must be maintained

    The slide exit requires its own 6-foot use zone extending from the end of the slide, separate from the general composite structure use zone.

  6. A seesaw (teeter-totter) is being installed. What defines the required use zone on the ends where the seats travel up and down?

    Answer: The use zone extends the length of the seesaw board plus 6 feet on each end

    The use zone at seesaw ends extends the length of the board plus a 6-foot clearance at each end to account for the arc of travel.

  7. Which of the following correctly describes the use zone on the sides (perpendicular to swing travel) of a traditional belt swing?

    Answer: Minimum 6 feet from the outer edge of the support structure

    On the sides of a swing (perpendicular to travel), the minimum use zone is 6 feet from the outer edge of the support structure.