Climbers and Upper Body Equipment Standards Questions and Answers Flashcards
7 cards from real CPSI practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 Climbers and Upper Body Equipment Standards Questions and Answers flashcards as text
A CPSI inspector notices corrosion on the main structural supports of a metal arch climber. Which factor determines whether immediate closure is required?
Answer: Pitting or deep corrosion that compromises structural integrity
Surface rust is cosmetic, but deep pitting or corrosion that reduces load-bearing capacity requires the equipment to be removed from service immediately.
During a routine CPSI inspection, a horizontal overhead ladder rung is found to rotate freely on its axis. What action is required?
Answer: Remove from service until the rung is properly secured
A freely rotating rung can cause a child to lose their grip unexpectedly mid-traverse, making it an immediate safety hazard requiring closure.
Which periodic maintenance task is most important for wood climbing structures?
Answer: Checking for splinters, rot, and structural integrity
Wood deteriorates through rot and checking, so annual inspection for splinters, rot, and structural compromise is the most critical maintenance task.
What is the most common injury type associated with monkey bars and overhead ladders?
Answer: Falls from the equipment onto the surface below
Falls are the most frequent and severe injury type associated with overhead upper body equipment, underscoring the importance of adequate safety surfacing beneath.
A rope climber's manila rope shows significant surface fraying at multiple points, though the core still appears intact. The correct CPSI response is to:
Answer: Remove from service and replace the rope
Significant surface fraying on manila rope indicates accelerated degradation and imminent failure risk; the rope must be replaced regardless of apparent core condition.
When inspecting upper body climbing equipment after a severe wind storm, what should the CPSI inspector examine first?
Answer: Structural connections, hardware tightness, and any visible deformation
High winds impose lateral and uplift forces on structural joints and hardware, so post-storm inspection should prioritize connection integrity and any bending or deformation.
A newly replaced S-hook on an overhead ring assembly is found to have a gap of 3 mm. According to CPSI inspection standards, this hardware:
Answer: Must be closed to less than 0.04 inches (1 mm) to pass inspection
S-hooks on playground equipment must have gaps of less than 0.04 inches (approximately 1 mm) to prevent clothing or fingers from catching during use.