CPO Security Technology and Equipment 3

Question 1

What is the primary purpose of an uninterruptible power supply (UPS) in a security system?

Accepted Answer

To provide temporary backup power to security equipment during a power outage, ensuring continuous operation

Answer

To increase the voltage available to camera systems during peak recording hours

Answer

To regulate internet bandwidth used by IP-based camera systems

Answer

To store recorded video footage when the primary DVR server is full

Question 2

What does an 'IP camera' have that a traditional analog CCTV camera does not?

Accepted Answer

The ability to transmit video over a network using an internet protocol address

Answer

A wider field of view lens

Answer

Built-in night vision capabilities

Answer

A longer cable reach of up to 1,000 feet

Question 3

Which of the following is an example of a 'vehicle barrier system' used in perimeter security?

Accepted Answer

Retractable bollards that prevent vehicle intrusion into a restricted area

Answer

A fence topped with razor wire

Answer

A security gatehouse staffed with armed officers

Answer

A camera system mounted at the entrance of a parking facility

Question 4

What is the 'chain of custody' requirement as it relates to digital security footage used as evidence?

Accepted Answer

A documented record proving that digital evidence has been properly collected, preserved, and handled without tampering from the moment of retrieval

Answer

The legal requirement that security footage must be reviewed by two officers before being submitted to police

Answer

The policy requiring all footage to be stored on encrypted drives before sharing with law enforcement

Answer

A rule that camera footage must be backed up to a second location within 24 hours of recording

Question 5

A security officer observes that a door contact sensor shows 'open' on the alarm panel, but the door appears closed. What should the officer do first?

Accepted Answer

Physically inspect the door to verify whether it is truly open, check the sensor alignment, and report the discrepancy to a supervisor

Answer

Immediately evacuate the building and contact emergency services

Answer

Silence the alarm panel and note it in the logbook as a false alarm

Answer

Reset the entire alarm system to clear the fault condition

Question 6

What is the correct term for a security system configuration where multiple components — cameras, alarms, and access control — are managed from a single software interface?

Accepted Answer

Integrated security management system (ISMS)

Answer

Unified threat detection platform (UTDP)

Answer

Centralized patrol monitoring network (CPMN)

Answer

Combined electronic security array (CESA)

Question 7

When a security officer tests an alarm system as part of a routine check, what is the most important first step?

Accepted Answer

Notify the alarm monitoring center and any relevant personnel that a test is being conducted to prevent a false emergency response

Answer

Ensure all cameras are recording before activating any alarm zones

Answer

Disable the system entirely before performing any testing procedures

Answer

Contact local law enforcement to inform them a test will occur