CPI Inspection Techniques & Reporting 3

Question 1

What is the primary purpose of performing an operational test on all pool valves during an inspection?

Accepted Answer

To verify valves move freely and can isolate equipment for service or emergency shut-off

Answer

Operational testing ensures valves function properly for both routine maintenance isolation and emergency shut-off, which is a key safety and serviceability check.

Question 2

During a pool inspection, the inspector observes the main drain cover is ANSI/APSP-16 compliant but is slightly domed and sitting above the floor surface. What additional check is necessary?

Accepted Answer

Confirm the cover is fully secured with all required fasteners and shows no cracks or damage

Answer

Even a compliant cover presents an entrapment risk if fasteners are missing, loose, or the cover is cracked, so confirming secure installation and physical integrity is essential.

Question 3

An inspector is evaluating a variable-speed pump installed on an older pool. Which condition would be considered a deficiency requiring correction?

Accepted Answer

The pump is wired directly to the timer without a dedicated time-of-use schedule programmed

Answer

Variable-speed pumps require programming that matches the pool's hydraulic needs and any applicable energy efficiency standards; no programmed schedule is a functional deficiency.

Question 4

When inspecting pool fencing, a CPI inspector finds the gate latch is on the inside but is within reach of a child who could reach through the fence pickets. This should be documented as:

Accepted Answer

A safety deficiency because the latch must not be reachable by a child from outside or through the barrier

Answer

Barrier codes require that latches not be reachable through or over the fence by a child, and a reachable inside latch defeats the purpose of the barrier.

Question 5

What is the correct inspector action when a pool heater's pressure switch or high-limit switch appears to have been bypassed with a jumper wire?

Accepted Answer

Document it as an immediate safety hazard and recommend removal of the bypass by a licensed technician

Answer

Bypassed safety switches remove critical overpressure or overtemperature protection, creating a serious hazard that must be flagged immediately and repaired by a professional.

(CPI) Certified Pool & Spa Inspector Practice Test

(CPI) Certified Pool & Spa Inspector Practice Test

CPI Inspection Techniques & Reporting 3