CPI Inspection Techniques & Reporting 2

Question 1

When inspecting a pool deck for trip hazards, what is the generally accepted maximum vertical displacement between adjacent sections?

Accepted Answer

1/4 inch

Answer

A vertical displacement greater than 1/4 inch between adjacent deck sections is typically flagged as a trip hazard during a CPI inspection.

Question 2

A CPI inspector notices the pool pump motor runs but produces very low water flow. Which inspection technique best identifies the root cause?

Accepted Answer

Check the pressure gauge on the filter and inspect the strainer basket for blockage

Answer

Low flow with a running motor typically indicates a restriction; checking filter pressure and strainer basket blockage directly identifies the most common causes.

Question 3

During a spa inspection, the inspector observes the air blower intake is located inside the equipment enclosure. What is the primary concern?

Accepted Answer

Carbon monoxide or exhaust gases could be drawn into the spa water

Answer

A blower intake inside an enclosed equipment space can draw combustion gases from nearby heaters into the spa, creating a CO poisoning hazard.

Question 4

Which method is most appropriate for an inspector to assess proper anti-entrapment drain cover installation?

Accepted Answer

Visually verify the cover is secured, undamaged, and matches the listed flow rate for the pump

Answer

CPI inspectors visually confirm the cover is properly secured, free of cracks, and rated for the pump's maximum flow to ensure anti-entrapment compliance.

Question 5

A pool inspection report should categorize a missing GFCI protection for a 120V receptacle within 20 feet of the pool as:

Accepted Answer

A safety hazard requiring immediate correction

Answer

Missing GFCI protection near a pool is an electric shock drowning risk and is classified as a safety hazard requiring immediate correction in CPI reporting.

(CPI) Certified Pool & Spa Inspector Practice Test

(CPI) Certified Pool & Spa Inspector Practice Test

CPI Inspection Techniques & Reporting 2