CPI CPI Spa & Hot Tub Specific Requirements 2

Question 1

What is the typical minimum turnover rate requirement for a public spa?

Accepted Answer

Every 30 minutes

Answer

Most state codes require spa water to turn over completely every 30 minutes due to the high bather-to-water-volume ratio.

Question 2

What suction fitting requirement specifically applies to spas to prevent hair entrapment?

Accepted Answer

Suction outlets must meet ANSI/APSP-16 entrapment protection standards

Answer

All spa suction outlets must comply with ANSI/APSP-16 to provide certified entrapment protection for hair and body.

Question 3

What minimum bather load restriction is typically posted for public spas?

Accepted Answer

Occupancy is set based on seating positions or square footage per code

Answer

Occupancy limits for public spas are set by state/local code, typically based on available seating positions or a defined square footage formula.

Question 4

During a CPI inspection, what should an inspector check regarding a spa's skimmer?

Accepted Answer

Presence, condition, and correct flow rate of the skimmer

Answer

The inspector must verify the skimmer is present, undamaged, and that flow through it falls within the manufacturer's rated range.

Question 5

What is the role of a thermal cover (hard cover) on a spa when it is not in use?

Accepted Answer

Prevents heat loss, evaporation, and unauthorized access

Answer

A thermal hard cover conserves heat, reduces chemical evaporation, and helps restrict unsupervised access when the spa is closed.

(CPI) Certified Pool & Spa Inspector Practice Test