Management Systems, Regulations & Assurance Flashcards
7 cards from real CMSP practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 Management Systems, Regulations & Assurance flashcards as text
Under 30 CFR Part 50, what is the timeframe in which a mine operator must report a fatality to MSHA?
Answer: Within 15 minutes
Part 50 requires operators to immediately notify MSHA of a fatality, and regulations specify notification within 15 minutes of the operator's knowledge.
A Job Hazard Analysis (JHA) is primarily used in mine safety management to:
Answer: Systematically identify and control hazards associated with specific tasks before work begins
A JHA breaks down a job into steps, identifies hazards at each step, and establishes controls before the task is performed.
Which element is NOT typically included in a formal root cause analysis following a mine accident?
Answer: Determination of fines to be assessed
Root cause analysis focuses on understanding why an accident occurred (causes and factors), not on determining financial penalties.
MSHA's 'significant and substantial' (S&S) violation standard, established in Cement Division, National Gypsum Co., requires that a violation be reasonably likely to cause:
Answer: An injury or illness of a reasonably serious nature
The S&S standard (from National Gypsum) requires the violation to be reasonably likely to cause an injury or illness of a reasonably serious nature.
Under the Mine Act, miners have the right to refuse work in what specific circumstance?
Answer: When they have a reasonable belief that the condition poses an imminent danger
Miners may refuse work if they have a reasonable, good-faith belief that a condition presents an imminent danger of death or serious physical harm.
In mine safety auditing, a 'compliance audit' differs from a 'management system audit' in that a compliance audit primarily evaluates:
Answer: Adherence to specific regulatory or internal standard requirements
A compliance audit checks whether specific legal or policy requirements are being met, while a management system audit evaluates the overall system's effectiveness.
Which MSHA enforcement action immediately withdraws miners from a dangerous area and cannot be modified by the operator until the condition is abated?
Answer: Section 107(a) Imminent Danger Order
A Section 107(a) Imminent Danger Order immediately removes all persons from the affected area until the imminent danger is abated.