CMS Safety Standards & Regulations 2

Question 1

Under OSHA's Lockout/Tagout (LOTO) standard 29 CFR 1910.147, how often must energy control procedures be reviewed?

Accepted Answer

Annually

Answer

OSHA 29 CFR 1910.147 requires periodic inspections of energy control procedures at least annually.

Question 2

Which NFPA standard specifically addresses the prevention of fires and explosions from flammable and combustible liquids in manufacturing facilities?

Accepted Answer

NFPA 30

Answer

NFPA 30, the Flammable and Combustible Liquids Code, governs storage, handling, and use of such liquids in industrial settings.

Question 3

A manufacturing plant handles chemicals above threshold planning quantities. Under EPCRA Section 302, what must the facility do?

Accepted Answer

Notify the State Emergency Response Commission and Local Emergency Planning Committee

Answer

EPCRA Section 302 requires facilities with Extremely Hazardous Substances above TPQs to notify the SERC and LEPC.

Question 4

In a process safety management (PSM) program under 29 CFR 1910.119, what is the primary purpose of a Process Hazard Analysis (PHA)?

Accepted Answer

To identify, evaluate, and control hazards in covered processes

Answer

A PHA systematically identifies and evaluates potential hazards in processes covered by PSM to allow appropriate controls.

Question 5

Which hierarchy-of-controls level is considered most effective for reducing workplace hazards?

Accepted Answer

Elimination

Answer

Elimination—physically removing the hazard—is the most effective level in the hierarchy of controls.

(CMS) Certified Manufacturing Specialist Practice Test