Safety Protocols & Compliance Checks Flashcards
7 cards from real CMO practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 Safety Protocols & Compliance Checks flashcards as text
What regulatory body in the US primarily governs occupational safety standards applicable to Mobilyze operators?
Answer: OSHA (Occupational Safety and Health Administration)
OSHA is the primary federal agency responsible for setting and enforcing workplace safety standards applicable to Mobilyze operators.
During a compliance check, an operator finds the unit's fire extinguisher is expired. What is the correct response?
Answer: Remove the unit from service until a valid fire extinguisher is installed
An expired fire extinguisher is a compliance failure; the unit must be taken out of service until a valid extinguisher is properly installed.
What is the correct protocol when a Mobilyze operator observes a coworker bypassing a safety guard?
Answer: Immediately notify the coworker and report the violation to a supervisor
Safety violations must be addressed immediately by notifying the coworker and reporting to a supervisor to prevent injury.
Which factor is most critical when determining whether ground conditions are safe for Mobilyze operation?
Answer: The load-bearing capacity of the surface relative to the unit's operating weight
The ground's load-bearing capacity must meet or exceed the unit's operating weight to prevent sinking, tipping, or structural failure.
How should an operator handle a compliance check discrepancy that was identified but not corrected in the previous shift's log?
Answer: Verify whether the discrepancy still exists and take appropriate corrective action
An unresolved log discrepancy must be physically verified and addressed with appropriate corrective action before assuming it has been resolved.
What is the purpose of establishing a safety perimeter around a Mobilyze unit during maintenance?
Answer: To prevent unauthorized personnel from entering the hazard zone during maintenance
A safety perimeter keeps unauthorized personnel out of the hazard zone where maintenance activities could cause injury to bystanders.
Which of the following best describes the 'hierarchy of controls' applied to safety hazards in Mobilyze operations?
Answer: Elimination first, followed by substitution, engineering controls, administrative controls, and PPE last
The hierarchy of controls prioritizes elimination of the hazard first, with PPE as the least effective last resort when other controls are not feasible.