Safety Protocols & Compliance Checks Flashcards
7 cards from real CMO practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 Safety Protocols & Compliance Checks flashcards as text
What is the primary purpose of a Job Hazard Analysis (JHA) before a Mobilyze operation?
Answer: To identify and mitigate potential hazards before work begins
A JHA proactively identifies potential hazards and establishes mitigation measures before the operation begins to prevent incidents.
During a Mobilyze compliance check, the hydraulic fluid level is found to be below minimum. What is the correct action?
Answer: Do not operate the unit until the fluid is topped off and the system is checked for leaks
Low hydraulic fluid requires topping off and checking for leaks before operation, as insufficient fluid can cause system failure and safety hazards.
Which safety protocol applies when two Mobilyze units must operate in close proximity?
Answer: A minimum safe separation distance must be maintained as defined in site safety protocols
Site safety protocols define minimum safe separation distances for units operating in proximity to prevent collisions.
An operator notices that a Mobilyze unit's travel alarm (reverse warning) is not sounding. What should the operator do?
Answer: Take the unit out of service until the alarm is repaired
A non-functioning travel alarm is a safety defect that requires removing the unit from service until the alarm is repaired and verified.
What is the significance of a safety data sheet (SDS) in Mobilyze maintenance compliance?
Answer: It provides hazard information and safe handling procedures for chemicals used in maintenance
An SDS provides critical hazard information and safe handling procedures for chemicals such as lubricants, hydraulic fluid, and cleaning agents used in maintenance.
Under what condition should a Mobilyze operator immediately halt operations and evacuate the area?
Answer: When a fire, toxic gas release, or structural emergency is detected nearby
Fire, toxic gas release, or structural emergencies require immediate halt of operations and evacuation as life safety takes absolute priority.
What must an operator verify about personal protective equipment (PPE) before beginning a Mobilyze compliance check?
Answer: That the PPE is appropriate for identified hazards, undamaged, and properly fitted
PPE must be appropriate for the specific hazards present, free of damage, and properly fitted to provide the protection it is rated for.