Post-Remediation Verification & Clearance Testing Flashcards
7 cards from real CMA practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 Post-Remediation Verification & Clearance Testing flashcards as text
What does a successful clearance determination in post-remediation verification indicate?
Answer: That mold conditions in the remediated area are similar to or below outdoor background levels
Clearance means that indoor mold levels in the remediated area are comparable to outdoor background levels, not that mold is completely absent.
If post-remediation verification sampling fails to meet clearance criteria, what must happen next?
Answer: Additional remediation must be performed, followed by repeat verification sampling
When clearance criteria are not met, the remediation contractor must perform additional cleaning or remediation, and the area must be re-tested before clearance can be granted.
Which laboratory analysis method provides genus- and species-level identification of mold in air samples, rather than just spore counts?
Answer: Culture (viable) analysis using malt extract agar
Viable culture analysis grows mold colonies from collected samples, allowing laboratory analysts to identify mold to the genus and species level, unlike direct microscopy spore counts.
What is the minimum recommended volume of air typically collected per spore trap sample during clearance testing?
Answer: 75 liters
IICRC S520 and industry protocols typically recommend collecting a minimum of 75 liters per spore trap cassette to ensure a representative air sample is obtained.
How should HVAC systems be handled prior to collecting post-remediation clearance air samples?
Answer: HVAC should be operating normally so conditions represent typical occupancy
HVAC should be operating under normal conditions during clearance sampling so that results reflect real-world occupancy conditions rather than artificially altered airflow.
Which of the following is an example of a surface sampling method used during post-remediation verification?
Answer: Tape lift or swab sample collected from a cleaned surface
Tape lift and swab samples are surface sampling methods used to detect residual mold on cleaned surfaces during post-remediation verification.
Which of the following conditions would typically cause a post-remediation clearance test to be postponed?
Answer: Visible moisture or ongoing water intrusion is still present in the remediated area
Active moisture or water intrusion must be resolved before clearance testing because ongoing water intrusion can support new mold growth and invalidate clearance results.