CLC Cabinetry & Millwork Installation 2

Question 1

When a cabinet must be installed against an out-of-plumb wall, what technique transfers the wall's irregular profile to the cabinet for a tight scribe fit?

Accepted Answer

Running a compass set to the widest gap along the wall surface

Answer

Setting a compass to the widest gap and running it along the wall transfers the exact wall profile onto the cabinet panel, which can then be trimmed to achieve a tight fit.

Question 2

What is the most common height for standard upper kitchen wall cabinets?

Accepted Answer

30 inches

Answer

30-inch upper cabinets are the most widely stocked standard height, fitting between the 18-inch countertop clearance and a typical 8-foot ceiling with space for crown molding.

Question 3

When laying out a corner base cabinet, what clearance condition must be verified before finalizing cabinet placement?

Accepted Answer

Adjacent cabinet doors and drawer pulls must open freely without interference

Answer

Corner cabinet layout requires confirming that opening one adjacent door does not block the neighboring door or drawer from fully opening.

Question 4

What reveal (gap) size is typically maintained around inset cabinet doors and drawer fronts for a uniform finished appearance?

Accepted Answer

1/8 inch

Answer

A 1/8-inch reveal is the standard gap around inset doors and drawer fronts, providing adequate clearance for wood movement while maintaining a clean, intentional look.

Question 5

When securing upper cabinets to the wall, fasteners must penetrate wall studs by a minimum of how much to achieve adequate holding strength?

Accepted Answer

1.5 inches

Answer

Screws must embed at least 1.5 inches into the stud after passing through the cabinet back and wall material to provide the required shear strength for loaded cabinets.

(CLC) Certified Lead Carpenter Practice Test

(CLC) Certified Lead Carpenter Practice Test

CLC Cabinetry & Millwork Installation 2