CITB Managers Permit to Work Systems 4

Question 1

The permit to work system for excavation near buried services must ensure:

Accepted Answer

Service locations have been confirmed by survey, a cable avoidance tool has been used, hand-digging exclusion zones around known services are specified, and emergency procedures are in place if a service is struck

Answer

A permit for excavation near services must: confirm service locations have been verified using plans and CAT equipment, specify the hand-dig exclusion zones, identify the emergency procedure if a service is struck, and confirm who to contact (gas emergency, electricity network operator) in an emergency.

Question 2

Why must only one permit to work be active at a time for a specific piece of equipment or work location?

Accepted Answer

To prevent conflicting authorisations that could result in simultaneous operations creating hazards — each piece of equipment or work area can only be under one set of permit conditions at a time

Answer

Multiple simultaneous permits for the same equipment or location can result in conflicting instructions and dangerous situations (e.g., one permit assumes an isolation is in place; another permits that isolation to be removed). One permit per location/equipment prevents such conflicts.

Question 3

A permit to work for roof work should specify:

Accepted Answer

The edges to be protected, the access arrangements, the load-bearing capacity of the roof, the weather conditions under which work may not proceed, the fall protection equipment required, and rescue arrangements

Answer

A roof work PTW must specify: edge protection requirements, safe access routes, roof load-bearing capacity (especially for fragile or older roofs), weather restrictions (wind speed, rain), fall protection equipment, and how a worker who falls will be rescued.

Question 4

What is a 'sign-on, sign-off' system in relation to permits to work?

Accepted Answer

A system where each worker entering the permit-controlled area signs on at the start of the permit and signs off at completion, confirming they were present and have left the area safely

Answer

A sign-on, sign-off system ensures that every person who enters a permit-controlled area is accounted for at all times. At permit close-out, checking that all workers have signed off confirms no one is left in a confined space, hazardous area, or isolated zone.

Question 5

A site operative asks the site manager if they can carry out work covered by a permit to work without the permit, as it 'will only take five minutes'. The site manager should:

Accepted Answer

Refuse — permit requirements apply regardless of the duration of the task. The permit ensures precautions are in place even for brief high-risk activities

Answer

The duration of a task does not determine whether a permit is needed — the risk level does. Many catastrophic incidents have occurred during brief 'five-minute jobs' without permits. The permit process ensures precautions are in place even for short tasks.

CITB HS&E Managers Practice Test

CITB HS&E Managers Practice Test

CITB Managers Permit to Work Systems 4