CIT - Certified Irrigation Technician System Installation and Layout 2

Question 1

When installing PVC irrigation mainline pipe, the trench depth should be a minimum of:

Accepted Answer

12 inches below grade with proper bedding material

Answer

Irrigation mainline pipe should be installed a minimum of 12 inches below grade to protect it from surface activities, mower aerification, and frost. In cold climates, deeper installation below the frost line is required, and proper bedding (free of rocks and debris) protects the pipe.

Question 2

A pipe sleeve (conduit) should be installed under hardscape (driveways, sidewalks, patios) during irrigation installation because:

Accepted Answer

It allows future pipe repair or replacement without demolishing the hardscape

Answer

Sleeves (typically one or two pipe sizes larger than the irrigation pipe) allow the irrigation pipe to be pulled through or replaced in the future without cutting through or removing the hardscape. This is a standard practice that saves significant cost and disruption for future repairs.

Question 3

When laying out sprinkler head locations for a rectangular lawn area, the preferred spacing pattern for maximum uniformity is:

Accepted Answer

Triangular (equilateral) spacing pattern

Answer

Triangular (equilateral) spacing provides the most uniform water distribution because each head overlaps coverage from multiple adjacent heads. In this pattern, rows are offset so heads are staggered rather than directly across from each other.

Question 4

What is the purpose of a valve manifold in irrigation system installation?

Accepted Answer

To group multiple zone valves together in one accessible location for easier maintenance and inspection

Answer

A valve manifold groups zone valves together in a single location (typically housed in a large valve box) so all valves can be accessed for maintenance, adjustment, or troubleshooting without searching for individual valves scattered throughout the landscape.

Question 5

When transitioning from PVC mainline pipe to PE lateral tubing, what type of fitting is used?

Accepted Answer

A threaded adapter from PVC to a barbed insert fitting for PE

Answer

The transition from PVC to PE requires a threaded PVC female adapter cemented to the PVC pipe, then a barbed insert male adapter threaded into it, onto which the PE tubing is pushed and clamped. This provides a secure, leak-free transition between the two materials.

CIT - Certified Irrigation Technician Practice Test

CIT - Certified Irrigation Technician Practice Test

CIT - Certified Irrigation Technician System Installation and Layout 2