CIT - Certified Irrigation Technician Certified Irrigation Technician System Installation and Layout 1

Question 1

What is the primary purpose of thrust blocks at mainline fitting locations during irrigation installation?

Accepted Answer

To resist hydraulic thrust forces at bends, tees, and end caps under pressure

Answer

Thrust blocks are concrete pads or mechanical restraints installed at changes in direction, tees, and end caps to counteract the hydraulic thrust forces generated by water pressure, which would otherwise push fittings apart and cause system failures.

Question 2

When installing pop-up spray heads in a lawn area, the top of the sprinkler body should be set:

Accepted Answer

Flush with or slightly below finished grade (approximately 1/4 inch)

Answer

Pop-up heads installed flush with or just below finished grade avoid damage from mowers and foot traffic while still allowing the pop-up stem to extend fully during operation for proper coverage.

Question 3

Before installing nozzles and sprinkler heads on newly installed lateral lines, the technician should:

Accepted Answer

Flush the lateral lines to remove pipe shavings, dirt, and debris

Answer

Flushing lateral lines before head installation removes construction debris, PVC shavings, and soil that entered during installation — contaminants that can clog nozzle filters and screens, shortening equipment life and reducing performance.

Question 4

What wire gauge is the industry standard for direct-burial irrigation control wiring between a residential controller and solenoid valves?

Accepted Answer

18 AWG

Answer

18 AWG UL-listed direct-burial wire is the accepted standard for residential irrigation control circuits, providing sufficient conductivity for 24VAC solenoid valve signals over the distances typically encountered in residential installations.

Question 5

At what point during mainline installation should a hydrostatic pressure test be performed?

Accepted Answer

Before the trench is backfilled, while all fittings and joints remain visible

Answer

Pressure testing before backfilling allows the installer to visually inspect every fitting, joint, and glued connection for leaks while they are still exposed and accessible, avoiding costly excavation if a failure is found after the trench is covered.

CIT - Certified Irrigation Technician Practice Test

CIT - Certified Irrigation Technician Practice Test

CIT - Certified Irrigation Technician Certified Irrigation Technician System Installation and Layout 1