CIT - Certified Irrigation Technician Certified Irrigation Technician Backflow Prevention Devices 1

Question 1

Which type of backflow prevention assembly uses two independent check valves and a differential pressure relief valve between them?

Accepted Answer

Reduced Pressure Zone Assembly (RPZ)

Answer

The Reduced Pressure Zone (RPZ) assembly contains two independently operating spring-loaded check valves with a differential pressure relief valve in the zone between them. This relief valve opens to atmosphere if the pressure in that zone rises, providing the highest level of backflow protection for high-hazard applications.

Question 2

An Atmospheric Vacuum Breaker (AVB) must NOT be installed in which of the following conditions?

Accepted Answer

Where the device will be subject to continuous pressure for more than 12 hours

Answer

An AVB is not designed to remain under continuous supply pressure. When subjected to pressure for more than 12 continuous hours, the internal float or poppet can become seated and fail to open when backpressure or backsiphonage occurs, defeating the device's purpose. It must be installed in systems that cycle off regularly.

Question 3

When testing a Double Check Valve Assembly (DCVA), a tester finds that Check Valve #1 reads 2.0 psi and Check Valve #2 reads 1.0 psi. What is the correct assessment?

Accepted Answer

Both checks pass; the assembly is in good working order

Answer

For a DCVA, each check valve must hold a minimum differential pressure of 1.0 psi. Check Valve #1 at 2.0 psi and Check Valve #2 at 1.0 psi both meet or exceed this threshold, so the assembly passes inspection. A reading of exactly 1.0 psi is acceptable — failure occurs only below 1.0 psi.

Question 4

A backflow preventer installed on an irrigation system serving a property with a fertilizer injector (chemigation) would BEST be protected by which assembly?

Accepted Answer

Reduced Pressure Zone Assembly (RPZ)

Answer

Chemical injection (chemigation) introduces a severe health hazard into the irrigation water. Chemicals entering the potable supply could be life-threatening, classifying this as a high-hazard cross-connection. Only an RPZ assembly provides the level of protection required for high-hazard applications because its differential relief valve actively discharges to atmosphere if either check valve fails.

Question 5

Where must the air gap distance between the supply pipe outlet and the flood level rim of a receiving vessel be set, at minimum, according to standard plumbing code?

Accepted Answer

Twice the internal diameter of the supply pipe, but not less than 1 inch

Answer

Standard plumbing codes specify that an air gap must be at least twice the internal diameter of the supply pipe, with an absolute minimum of 1 inch. This ensures that even under the worst flooding conditions, the flood rim cannot reach the supply outlet, maintaining a true physical separation between the potable water supply and the receiving vessel.

CIT - Certified Irrigation Technician Practice Test

CIT - Certified Irrigation Technician Practice Test

CIT - Certified Irrigation Technician Certified Irrigation Technician Backflow Prevention Devices 1