Building Codes & Standards Flashcards
7 cards from real CFP practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 Building Codes & Standards flashcards as text
Under the Americans with Disabilities Act (ADA), which fence-related element must meet specific reach range and operability requirements?
Answer: Gate hardware and latches
ADA requires that gate hardware, including latches and handles, be operable with one hand without tight grasping and be within accessible reach ranges.
OSHA standard 29 CFR 1926.502 requires guardrails on walking and working surfaces. When does a fence serve as an acceptable perimeter guardrail?
Answer: When it meets top rail, mid-rail, and toeboard load requirements
A fence may qualify as a guardrail if it meets OSHA's structural load requirements including a top rail capable of withstanding 200 lbs of force, mid-rail, and toeboard specifications.
Which building code section specifically addresses the use of barbed wire and electrified fences in residential zones?
Answer: Local zoning ordinance and municipal code
Restrictions on barbed wire and electrified fences in residential areas are typically governed by local zoning ordinances, which vary by municipality.
When a fence post is set in concrete near an underground utility line, what minimum clearance is generally required before excavation?
Answer: 18 inches
Most state utility notification laws and safe digging guidelines require hand-digging or vacuum excavation within 18 inches of marked utility lines.
The IRC Section R105 requires a building permit for fences that exceed what height threshold in most jurisdictions?
Answer: 6 feet
The IRC sets 6 feet as the common threshold above which a building permit is generally required for fence construction, though local amendments may lower this.
What is the primary purpose of a Certificate of Occupancy (CO) or final inspection sign-off after fence installation?
Answer: To confirm the fence was built in compliance with approved plans and applicable codes
A final inspection and CO (or equivalent sign-off) verifies that the installed fence matches the approved permit drawings and meets all applicable code requirements.
Which ASTM standard specifies dimensions and mechanical properties for steel pipe used in chain-link fence framework?
Answer: ASTM F1083
ASTM F1083 covers the standard specification for pipe, steel, hot-dipped zinc-coated welded and seamless used in chain-link fence framework.