CFOT - Certified Fiber Optic Technician Splicing Techniques Questions and Answers

Question 1

A technician performs a fusion splice but the OTDR trace shows a significant loss of 0.5 dB. Microscopic inspection of a subsequent cleave from the same cleaver reveals a jagged, angled end-face. Which of the following is the MOST likely cause of the high splice loss?

Accepted Answer

A worn-out or damaged cleaver blade

Answer

A high-quality splice requires a perfectly flat and perpendicular fiber end-face. A worn, chipped, or dirty cleaver blade will produce a poor cleave with imperfections like lips, chips, or angles, preventing the fibers from aligning and fusing correctly, which results in high signal loss.

Question 2

When comparing fusion splicing and mechanical splicing, which statement is generally true?

Accepted Answer

Fusion splicing results in a more permanent bond with lower typical insertion loss.

Answer

Fusion splicing uses an electric arc to weld two fibers together, creating a continuous, permanent connection. This method typically results in a very low insertion loss (often <0.1 dB) and excellent back reflection performance, making it superior in performance to mechanical splicing, which simply aligns the fibers in a housing.

Question 3

A technician is preparing to protect a newly completed fusion splice. What is the correct procedure regarding the heat-shrink splice protection sleeve?

Accepted Answer

Slide the sleeve onto one of the fibers BEFORE performing the fusion splice.

Answer

The splice protection sleeve must be placed onto one of the fiber strands before the fibers are stripped, cleaved, and fused. If this step is forgotten, the splice would have to be broken and redone to install the sleeve. After splicing, the sleeve is centered over the bare fiber and heated in the fusion splicer's oven to shrink and seal it.

Question 4

Which of the following describes the primary purpose of the 'cleaving' step in the fiber optic splicing process?

Accepted Answer

To create a precise, flat, and perpendicular end-face on the fiber.

Answer

Cleaving is the critical process of scoring and breaking the glass fiber to produce a perfectly smooth, flat end-face that is exactly 90 degrees to the fiber axis. This precise surface is essential for proper light transmission across the splice point with minimal loss or reflection.

Question 5

During a fusion splice, the technician notices tiny air pockets or voids near the splice point on the splicer's screen, and the resulting splice has high loss. This common defect is often referred to as:

Accepted Answer

Bubbles or inclusions

Answer

Bubbles or inclusions are voids that can form in the glass during the fusion process. They are often caused by contamination on the fiber end-faces (which burns off and creates gas) or incorrect fusion parameters, such as excessive arc power or duration. These defects disrupt the light path and increase splice loss.

CFOT - Certified Fiber Optic Technician Practice Test

CFOT - Certified Fiber Optic Technician Practice Test

CFOT - Certified Fiber Optic Technician Splicing Techniques Questions and Answers