CFI Inspection Procedures & Reporting 2

Question 1

When an inspector discovers an imminent hazard during a routine inspection, what is the FIRST action that should be taken?

Accepted Answer

Notify the occupant and require immediate corrective action or closure

Answer

An imminent hazard poses immediate danger to life and must be addressed on the spot by notifying the occupant and requiring immediate correction or closure of the affected area.

Question 2

Which document is typically used to formally notify an owner of fire code violations found during an inspection?

Accepted Answer

Notice of violation or correction notice

Answer

A notice of violation (or correction notice) is the formal document issued to the owner or occupant that identifies violations and establishes a timeframe for compliance.

Question 3

What is the primary purpose of a re-inspection after violations are cited?

Accepted Answer

To verify that previously cited violations have been corrected

Answer

A re-inspection is conducted specifically to verify that all violations cited in the original notice have been corrected within the required timeframe.

Question 4

When documenting conditions during a fire inspection, photographs should be taken from which perspective FIRST?

Accepted Answer

Wide angle to establish the overall context and location

Answer

Establishing shots from a wide angle should be taken first to document the overall context and location before close-up photos capture the specific deficiency.

Question 5

Under NFPA 1, which of the following is the inspector's responsibility regarding trade secrets observed during an inspection?

Accepted Answer

Maintain confidentiality of proprietary processes while still reporting fire hazards

Answer

Inspectors must maintain confidentiality of proprietary or trade secret information observed during an inspection while still fulfilling their obligation to report fire and life safety hazards.

(CFI) Certified Fire Inspector Practice Test

(CFI) Certified Fire Inspector Practice Test

CFI Inspection Procedures & Reporting 2