CFA OSHA 29 CFR 1910.178 2

Question 1

According to OSHA 29 CFR 1910.178, what determines the maximum load a forklift can safely carry?

Accepted Answer

The load capacity plate on the truck

Answer

OSHA requires operators to follow the load capacity plate (nameplate) affixed to the truck, which specifies the maximum allowable load.

Question 2

Under OSHA 29 CFR 1910.178, when must a forklift be removed from service?

Accepted Answer

When any unsafe condition is found during inspection

Answer

The regulation requires that any truck found to be unsafe must be removed from service until it has been restored to safe operating condition.

Question 3

OSHA 29 CFR 1910.178 requires that forklift operators must be recertified when which of the following occurs?

Accepted Answer

The operator is involved in a near-miss or accident

Answer

Retraining and re-evaluation are required when an operator is involved in an accident or near-miss incident, among other triggering events.

Question 4

What does the 'stability triangle' concept in forklift operation refer to?

Accepted Answer

The triangular area formed by the two front wheels and the rear axle pivot point

Answer

The stability triangle is the area defined by the two front drive wheels and the center of the rear axle, within which the forklift's combined center of gravity must remain to prevent tipping.

Question 5

Per OSHA 29 CFR 1910.178, how should loads be positioned on the forks for travel?

Accepted Answer

Tilted back with forks 4–6 inches above the ground

Answer

Loads should be carried with the forks tilted back and raised only 4–6 inches off the ground to maintain stability during travel.

CFA Practice Test

CFA Practice Test

CFA OSHA 29 CFR 1910.178 2