CFA Load Handling & Warehouse Management 3 — Questions and Answers
Question 1: What is the danger of exceeding the rated capacity on only one side of the forks?
- It only affects speed, not stability
- It creates an uneven load that can tip the forklift sideways (Correct answer)
- It reduces battery life on electric forklifts
- It automatically triggers a load alert
Correct answer: It creates an uneven load that can tip the forklift sideways
An off-center overload creates lateral instability, risking a sideways tip even if total weight is within rated capacity.
Question 2: When should a forklift operator check the load center distance marked on the data plate?
- Only when lifting loads over 2,000 lbs
- Every time an attachment changes the load geometry (Correct answer)
- Only during the pre-shift inspection
- Only when operating on ramps
Correct answer: Every time an attachment changes the load geometry
Attachments change the effective load center, which can significantly reduce actual safe capacity.
Question 3: What is the purpose of a load backrest extension on a forklift?
- To increase the maximum rated capacity
- To prevent the load from falling backward onto the mast and operator (Correct answer)
- To allow carrying taller loads above maximum height
- To guide the forks into pallet openings
Correct answer: To prevent the load from falling backward onto the mast and operator
The load backrest extension acts as a barrier to stop loads from sliding back into the mast or operator's compartment.
Question 4: A warehouse aisle is marked with a yellow floor stripe. What does this stripe typically indicate?
- A pedestrian-only zone
- The boundary of the forklift travel lane (Correct answer)
- A hazardous chemical storage area
- The area under overhead sprinklers
Correct answer: The boundary of the forklift travel lane
Yellow floor stripes typically designate forklift traffic lanes to separate vehicle and pedestrian paths.
Question 5: When traveling on a ramp with a loaded forklift, which direction should the load face?
- Always face the load uphill regardless of direction (Correct answer)
- Face the load downhill to improve braking
- Load faces uphill going up, downhill going down
- Load direction does not matter on ramps
Correct answer: Always face the load uphill regardless of direction
The load must always face uphill on a ramp to prevent the load from sliding off the forks due to gravity.
Question 6: What is the correct action when a forklift operator encounters a spill on the warehouse floor?
- Drive through it slowly to assess traction
- Report it and avoid the area until it is cleaned up (Correct answer)
- Use the forklift to push the spill to the side
- Continue operating if the spill is small
Correct answer: Report it and avoid the area until it is cleaned up
Spills create slip hazards and must be reported and avoided until properly cleaned to prevent accidents.
Question 7: What does a yellow 'X' painted on the warehouse floor typically mean?
- Preferred forklift parking spot
- No parking or obstruction allowed in this area (Correct answer)
- Hazardous material storage zone
- Fire extinguisher location
Correct answer: No parking or obstruction allowed in this area
A yellow 'X' on the floor marks areas that must remain clear, such as in front of fire exits or emergency equipment.
CFA Load Handling & Warehouse Management 3
What is the danger of exceeding the rated capacity on only one side of the forks?