Practice Test GeeksCFA Practice Test
← All CFA Flashcard Decks

OSHA Regulations & Compliance Standards Flashcards

7 cards from real CFA practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 OSHA Regulations & Compliance Standards flashcards as text

  1. OSHA's general duty clause (Section 5(a)(1) of the OSH Act) can be cited for forklift hazards when:

    Answer: No specific OSHA standard exists but a recognized hazard is present

    The general duty clause allows OSHA to cite employers for recognized hazards that cause or are likely to cause death or serious harm even without a specific regulation.

  2. Which OSHA requirement specifically addresses operator seat belts on counterbalanced sit-down forklifts?

    Answer: Employers must ensure operators use seat belts or restraint systems when available

    OSHA requires employers to ensure operators use seat belts or operator restraint systems when the forklift is equipped with one.

  3. How does OSHA classify forklift trucks by fuel and design type for safe use in different environments?

    Answer: Into seven designations (D, DS, DY, E, ES, EE, EX) based on atmospheric hazard levels

    OSHA classifies powered industrial trucks into seven designations (D through EX) to match the right truck to the hazardous atmosphere level of the workplace.

  4. According to OSHA, what action must an employer take when a forklift operator is observed operating unsafely even with no accident occurring?

    Answer: Retrain the operator before allowing them to continue operating

    OSHA requires retraining whenever an operator is observed operating a truck in an unsafe manner, regardless of whether an incident occurred.

  5. What is the OSHA-required minimum width of an aisle used exclusively for pedestrian traffic adjacent to forklift operations?

    Answer: At least 3 feet wider than the largest equipment used or a minimum of 4 feet for pedestrian-only aisles

    OSHA requires permanent aisles to be at least 3 feet wider than the largest equipment or load, with pedestrian aisles at minimum 4 feet wide.

  6. Under OSHA standards, which of the following correctly describes safe refueling procedures for LP gas (propane) forklifts?

    Answer: Engine off, away from ignition sources, in a ventilated area with no smoking permitted

    OSHA requires that propane cylinder exchanges occur with the engine off, away from ignition sources, in ventilated areas, with smoking prohibited.

  7. OSHA's powered industrial truck standard requires that forklift training include which two major components?

    Answer: Formal instruction (lecture/video/written) AND practical hands-on training and evaluation

    OSHA mandates that forklift training include both formal instruction (classroom, video, written material) and practical hands-on training with an evaluation by a qualified person.