Practice Test Geeks(CET) Certified Elevator Technician Practice Test
← All CET Flashcard Decks

Safety Codes & Regulations Flashcards

7 cards from real CET practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Safety Codes & Regulations flashcards as text

  1. Which ASME A17.1 rule governs the requirement for car enclosures to have a minimum height of 7 feet?

    Answer: Rule 2.14.1

    ASME A17.1 Rule 2.14.1 specifies that car enclosures for passenger elevators must have a minimum height of 7 feet (84 inches) from floor to ceiling.

  2. Under ASME A17.1, Phase II firefighters' service requires that the elevator respond only to which controls?

    Answer: Car operating panel buttons only

    During Phase II firefighters' service, the elevator responds exclusively to controls within the car operating panel, removing hall call registration.

  3. What is the minimum illumination level required inside an elevator car under ASME A17.1?

    Answer: 5 foot-candles

    ASME A17.1 requires a minimum of 5 foot-candles of illumination at the car threshold and floor level when the car is occupied.

  4. Under OSHA 29 CFR 1910.68, the maximum rated load for a manlift step platform is:

    Answer: 250 lbs

    OSHA 29 CFR 1910.68 specifies that manlift step platforms must be designed to carry a maximum load of 250 lbs.

  5. When an elevator is taken out of service for maintenance, ASME A17.1 requires that the car doors be locked or the car be parked:

    Answer: At the bottom landing with doors closed

    When taken out of service, the elevator car should be parked at the bottom terminal landing with the car and hoistway doors closed and locked to prevent access.

  6. Which edition of the ICC/ANSI A117.1 standard governs accessible elevator cab dimensions used in ADA compliance?

    Answer: The edition adopted by the local jurisdiction

    Accessibility requirements default to the ICC/ANSI A117.1 edition adopted by the local jurisdiction, which varies by state and municipality.

  7. Under ASME A17.1, the car safety device on a traction elevator is required to stop and hold the car when the governor trips at what condition?

    Answer: Only when the car is descending

    Traditional Type B safeties on traction elevators are designed to activate during descending overspeed; ascending car protection requires separate devices under newer code editions.