← All CES Flashcard Decks

Health and Safety Management Flashcards

7 cards from real CES practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Health and Safety Management flashcards as text
  1. The National Institute for Occupational Safety and Health (NIOSH) recommended exposure limit (REL) for respirable crystalline silica is:

    Answer: 0.05 mg/m³

    NIOSH recommends a REL of 0.05 mg/m³ for respirable crystalline silica as a TWA, which matches OSHA's 2016 PEL for general industry.

  2. A Bloodborne Pathogen Exposure Control Plan under 29 CFR 1910.1030 must be reviewed and updated at least:

    Answer: Annually

    OSHA requires the Exposure Control Plan to be reviewed and updated at least annually, and whenever new or modified tasks affect occupational exposure.

  3. During environmental site assessment, a site safety and health plan (SSHP) is MOST similar in purpose to which OSHA document requirement?

    Answer: Written program required under HAZWOPER (29 CFR 1910.120)

    HAZWOPER (29 CFR 1910.120) requires a site-specific written safety and health program (SSHP) to address hazards, PPE levels, decontamination, emergency response, and training before fieldwork begins.

  4. Which PPE protection level under EPA/NIOSH guidance provides the HIGHEST level of respiratory and skin protection?

    Answer: Level A with SCBA inside a fully encapsulating suit

    Level A provides maximum protection with a fully encapsulating vapor-protective suit and SCBA, protecting against the highest concentrations of vapors, gases, and particulates that pose skin absorption risks.

  5. A worker reports symptoms of headache and dizziness after entering a storage area. Air monitoring shows 19.1% oxygen. What action is immediately required?

    Answer: Evacuate immediately — oxygen-deficient atmosphere requires SCBA or evacuation

    OSHA defines oxygen-deficient atmosphere as below 19.5%; 19.1% O2 is oxygen-deficient, requiring immediate evacuation and entry only with supplied-air respiratory protection.

  6. Under the EPA's Risk Management Program (RMP, 40 CFR Part 68), a Program 3 facility must include which element NOT required for Program 1?

    Answer: Process Hazard Analysis and mechanical integrity program

    Program 3 (high-hazard processes) requires a full prevention program including PHA, operating procedures, mechanical integrity, management of change, and pre-startup reviews — requirements absent from Program 1.

  7. An environmental health and safety audit finds that a facility lacks written procedures for emergency eyewash station inspection. Which OSHA standard is most directly applicable?

    Answer: 29 CFR 1910.151 — Medical Services and First Aid

    29 CFR 1910.151 requires adequate first-aid supplies and facilities, including eyewash stations near corrosive chemical operations, with ANSI Z358.1 providing inspection frequency guidance.