Practice Test GeeksCertified Pipefitter Practice Test
← All PIPEFITTER Flashcard Decks

Core Responsibilities Flashcards

6 cards from real PIPEFITTER practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 6 Core Responsibilities flashcards as text

  1. What is meant by 'pipe alignment' and why is it critical before welding flanges?

    Answer: Ensuring pipe ends and flanges are parallel and concentric so the joint seals properly under operation

    Pipe alignment means ensuring the mating faces are parallel and the bores are concentric, which is essential for leak-free flange joints and proper weld fit-up.

  2. When installing a new section of pipe in an existing operating plant, what is the term for the final weld that closes the last gap in the new section?

    Answer: Closure weld (or golden weld/tie-in weld)

    The final weld that closes the loop in a pipe system is called a closure weld, also known as a tie-in weld or golden weld.

  3. What is a pipefitter's responsibility regarding 'as-built' drawings?

    Answer: Mark up construction drawings to show any deviations from the design made during installation

    Pipefitters are responsible for marking construction drawings to reflect any field changes made during installation, which become the basis for as-built records.

  4. What does a pipefitter do during a 'pre-hydro walk-down'?

    Answer: Inspect the piping system to verify all welds are complete, supports are installed, and temporary items are removed before pressure testing

    A pre-hydro walk-down is a systematic inspection to confirm the piping system is ready for hydrostatic testing — all welds done, supports installed, blinds/vents in place, and instruments removed.

  5. Which ASME code primarily governs the fabrication and installation of process plant piping?

    Answer: ASME B31.3 Process Piping

    ASME B31.3 is the standard that governs process plant piping, covering design, materials, fabrication, examination, and testing.

  6. What is the purpose of performing a 'cold spring' or 'cold pull' when installing a pipe system?

    Answer: To pre-stress the pipe during installation so it reaches a stress-free state at operating temperature

    Cold spring (cold pull) involves installing a pipe slightly short of its natural length so that thermal expansion during operation pulls the system to its intended stress-free position.