CENWAT Hot Water Systems (Unvented/Vented)

Question 1

What qualification must a plumber hold to install an unvented hot water storage system in the UK?

Accepted Answer

G3 Unvented Hot Water Storage qualification

Answer

Under Building Regulation G3, any person installing an unvented hot water storage system over 15 litres must hold a current G3 Unvented Hot Water Storage qualification. This ensures the installer understands the specific safety requirements, as unvented systems operate under mains pressure.

Question 2

What is the correct order of safety devices on an unvented hot water cylinder from the water supply inlet?

Accepted Answer

Pressure reducing valve, check valve, expansion vessel, temperature and pressure relief valve

Answer

The correct order on an unvented system is: pressure reducing valve, check valve (or combined set), then the expansion vessel, and finally the temperature and pressure relief valve on the cylinder itself. This ensures incoming pressure is controlled, backflow is prevented, expansion is accommodated, and overpressure protection is in place.

Question 3

At what temperature should the temperature and pressure relief valve on an unvented cylinder operate?

Accepted Answer

90-95 degrees C

Answer

The temperature and pressure relief valve on an unvented hot water cylinder is factory set to operate at 90-95 degrees C. This is above the normal thermostat setting of typically 60-65 degrees C and the overheat thermostat at typically 80-85 degrees C, making it the final line of defence.

Question 4

What is the maximum working pressure rating typically specified for an unvented hot water cylinder?

Accepted Answer

10 bar

Answer

Unvented hot water cylinders are typically rated to a maximum working pressure of 10 bar, though they are normally operated at 3-3.5 bar via a pressure reducing valve. The 10 bar rating provides a significant safety margin. The pressure relief valve is typically set at 6-7 bar.

Question 5

What is the minimum discharge pipe size from the temperature and pressure relief valve to the tundish on an unvented cylinder?

Accepted Answer

15mm

Answer

The discharge pipe from the T&P relief valve to the tundish must be a minimum of 15mm, the same size as the relief valve outlet. From the tundish onwards, the pipe must increase by at least one pipe size to minimum 22mm and must have a continuous fall to a safe, visible discharge point.

ACS CENWAT Practice Test

ACS CENWAT Practice Test

CENWAT Hot Water Systems (Unvented/Vented)