CENWAT Flue Requirements & Pressure Relief 2

Question 1

What must be done if a gas boiler flue terminal is within 1 metre of a window?

Accepted Answer

A plume management kit must be fitted or the terminal repositioned to achieve the minimum clearance

Answer

If a flue terminal is closer than the minimum required clearance to an openable window, a plume management kit can redirect the flue exhaust to an acceptable position, or the terminal must be relocated.

Question 2

What is a plume management kit?

Accepted Answer

An extension that redirects the condensate plume and flue gas exhaust upwards or away from windows and openings

Answer

A plume management kit redirects the white condensate plume from a condensing boiler's flue terminal away from windows, doors and pathways where it may cause nuisance or re-enter the building.

Question 3

What is the minimum clearance required between a gas boiler flue terminal and a gas meter?

Accepted Answer

300 mm

Answer

A flue terminal must not be within 300 mm of a gas meter, regulator or any meter housing to prevent gas ignition if there is a minor gas leak at the meter.

Question 4

What action should be taken if a flue is found to be leaking flue gases into a room?

Accepted Answer

Immediately turn off the appliance, ventilate the room, warn occupants and do not use until repaired

Answer

A leaking flue is an immediately dangerous (ID) situation; the appliance must be shut down immediately, the room ventilated, occupants warned, and the appliance made safe before use.

Question 5

What is the maximum CO level in a flue gas (as measured at the flue terminal) that is generally considered acceptable for a gas boiler?

Accepted Answer

CO:CO2 ratio below 0.004 (or as specified by the manufacturer's commissioning data)

Answer

The CO:CO2 ratio method is used to assess combustion quality; a ratio above 0.004 may indicate incomplete combustion and requires investigation. Absolute CO limits vary by manufacturer.

ACS CENWAT Practice Test

ACS CENWAT Practice Test

CENWAT Flue Requirements & Pressure Relief 2