CEA Reading Electrical Blueprints Questions and Answers

Question 1

An apprentice is reviewing a set of electrical blueprints for a commercial building and needs to find detailed information about the circuit breaker sizes, the loads served by each circuit, and the total connected load for Panel 'LP-1'. In which part of the blueprints would this information most likely be found?

Accepted Answer

The Panelboard Schedule

Answer

Panelboard schedules are dedicated tables on electrical drawings that provide a detailed breakdown of each circuit within a specific panel. They list the circuit number, breaker size and type, wire size, phase connection, a description of the load (e.g., 'receptacles - office 101'), and the calculated load in volt-amperes.

Question 2

While looking at an electrical floor plan, an apprentice sees a symbol consisting of a circle with two short, parallel lines drawn through it, located on a wall. What does this standard symbol typically represent?

Accepted Answer

A duplex receptacle

Answer

This is a standard symbol used on electrical blueprints in North America to represent a common duplex receptacle, which is the type of outlet used for general purpose plug-in devices.

Question 3

An apprentice is tasked with determining the required length of a home run from a receptacle to the panel as shown on a floor plan. The plan has a noted scale of 1/4" = 1'-0". If the apprentice measures the distance on the paper to be 7.5 inches, what is the actual horizontal distance of the run?

Accepted Answer

30 feet

Answer

With a scale of 1/4" = 1'-0", every full inch on the drawing represents 4 feet in reality (1 divided by 1/4 = 4). Therefore, the actual distance is calculated by multiplying the measured inches by 4 feet/inch: 7.5 inches * 4 feet/inch = 30 feet.

Question 4

On an electrical drawing set, which document provides a simplified overview of the power distribution system, showing the path of power from the utility service to panelboards and major equipment, without showing the physical location of the components?

Accepted Answer

A One-Line Diagram

Answer

A one-line diagram (also called a single-line diagram) is specifically designed to show the logical connections and flow of a power system in a simplified format. It uses single lines and symbols to represent the entire system, from the power source to the final distribution panels and large equipment.

Question 5

During an installation, an apprentice notes that the electrical drawings call for Type NM cable for a circuit, but the project's written specifications explicitly require that the same circuit be installed in EMT conduit. In a case of conflict between the drawings and the specifications, which document is generally considered to take precedence?

Accepted Answer

The written specifications, as they provide detailed requirements.

Answer

In standard construction contract hierarchy, the written specifications provide a higher level of detail and requirements and generally govern over the drawings in case of a direct conflict. While submitting a Request for Information (RFI) is the correct procedural step to resolve the conflict, the specifications are considered the governing document.

(CEA) Certified Electrical Apprentice Practice Test

(CEA) Certified Electrical Apprentice Practice Test

CEA Reading Electrical Blueprints Questions and Answers