CDT Safety Regulations & OSHA Compliance 2

Question 1

Under OSHA's Hazard Communication Standard (HazCom), what document must accompany hazardous chemicals in the workplace?

Accepted Answer

Safety Data Sheet (SDS) with 16 standardized sections

Answer

The HazCom Standard (29 CFR 1910.1200) requires Safety Data Sheets with 16 standardized sections aligned with the GHS system.

Question 2

Which OSHA standard specifically governs ergonomics and repetitive motion concerns in drafting and CAD workstations?

Accepted Answer

General Duty Clause Section 5(a)(1)

Answer

OSHA's General Duty Clause requires employers to provide a workplace free from recognized hazards, including ergonomic risks at CAD workstations.

Question 3

When drafters use plotters or printers with solvent-based inks, which OSHA standard most directly applies?

Accepted Answer

Hazard Communication Standard 29 CFR 1910.1200

Answer

Solvent-based inks are hazardous chemicals covered under the HazCom Standard, requiring SDS availability and employee training.

Question 4

What is the OSHA-required minimum aisle width for general industry workplaces such as drafting offices?

Accepted Answer

36 inches

Answer

29 CFR 1910.22 requires permanent aisles and passageways to be at least 28 inches wide, though 36 inches is the general industry standard.

Question 5

A drafting technician working on a construction site must wear a hard hat. Under which OSHA standard is this PPE requirement found?

Accepted Answer

29 CFR 1926.100

Answer

29 CFR 1926.100 covers head protection requirements in construction environments, mandating hard hats in areas with head injury risks.

(CDT) Certified Drafting Technician Practice Test