CCT Tools & Equipment Operation 4

Question 1

A calibration technician needs to measure a bore diameter of 25.000 mm ± 0.002 mm. Which instrument is most appropriate?

Accepted Answer

Bore gauge with 0.001 mm resolution set with a ring gauge

Answer

A bore gauge set with a calibrated ring gauge provides internal diameter measurement at 0.001 mm resolution, suitable for the ±0.002 mm tolerance.

Question 2

When performing a multi-point calibration of a pressure transmitter, which sequence of applied pressures is required by most calibration procedures?

Accepted Answer

Ascending then descending points to detect hysteresis

Answer

Both ascending and descending pressure series are required to detect and quantify hysteresis error in the transmitter's output.

Question 3

Which environmental parameter most significantly affects the accuracy of a laser interferometer used for length measurement in a calibration laboratory?

Accepted Answer

Air temperature and refractive index

Answer

The laser interferometer measures length based on the laser wavelength in air; air temperature, pressure, and humidity affect the refractive index and thus the effective wavelength.

Question 4

A technician is calibrating a tachometer using a stroboscope. If the stroboscope flash rate is set to 1800 flashes per minute and the rotating target appears stationary, the shaft speed is:

Accepted Answer

Any multiple of 1800 RPM

Answer

A stationary image occurs when the shaft speed equals any integer multiple of the strobe rate (1800, 3600, 5400 RPM), so the actual speed must be verified by reducing the strobe rate.

Question 5

What is the correct way to handle gage blocks after use to prevent corrosion and maintain accuracy?

Accepted Answer

Clean with solvent, apply a thin film of rust inhibitor, and store in a case

Answer

Gage blocks must be cleaned with solvent to remove fingerprints and contaminants, coated with rust inhibitor, and stored in a protective case to maintain their surface quality and dimensional accuracy.

(CCT) Certified Calibration Technician Practice Test

(CCT) Certified Calibration Technician Practice Test

CCT Tools & Equipment Operation 4