CCT System Operation & Monitoring 5

Question 1

A Casper system's software control system logs a 'watchdog timeout' fault. What does this indicate?

Accepted Answer

A critical software process failed to respond within the expected time window

Answer

A watchdog timeout means a monitored software process stopped responding, indicating a software hang or hardware communication failure requiring system restart and investigation.

Question 2

When reviewing Casper run-to-run data, a technician identifies that etch rate drifts upward by approximately 2% with each consecutive wafer in a lot. This trend MOST likely points to:

Accepted Answer

Chamber conditioning effects from process residue buildup changing plasma chemistry

Answer

Progressive chamber conditioning—where chamber walls and surfaces change state as a lot progresses—commonly causes systematic run-to-run etch rate drift.

Question 3

A Casper system is equipped with a capacitance manometer and a Pirani gauge measuring the same chamber. At 10 mTorr, which gauge provides the MORE accurate pressure reading?

Accepted Answer

Capacitance manometer, because it is gas-species independent and highly accurate

Answer

Capacitance manometers measure pressure mechanically and are independent of gas species, making them more accurate than thermal conductivity-based Pirani gauges in the mTorr range.

Question 4

During a Casper system automated startup sequence, the system halts at the 'roughing to process pressure' step. The roughing pump is running. What should the technician check first?

Accepted Answer

Roughing valve status and roughing pump ultimate pressure

Answer

If the system stalls during roughing, the roughing valve may not have opened or the pump's ultimate pressure may be too high to reach the handoff setpoint.

Question 5

A Casper system's maintenance log shows that the same O-ring seal on a gate valve has been replaced three times in two months. What is the MOST appropriate corrective action?

Accepted Answer

Investigate root cause—check for chemical compatibility, improper installation torque, or valve cycling frequency

Answer

Repeat failures of the same component indicate a systemic root cause such as wrong material, installation error, or excessive cycling rather than random wear.

(CCT) Certified Casper Technician Practice Test

(CCT) Certified Casper Technician Practice Test

CCT System Operation & Monitoring 5