Practice Test Geeks(CCI) Certified Construction Inspector Practice Test
← All CCI Flashcard Decks

Safety Regulations & Compliance Flashcards

7 cards from real CCI practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Safety Regulations & Compliance flashcards as text

  1. Which document must an employer provide to workers before they begin work in a confined space classified as permit-required?

    Answer: A written entry permit

    OSHA 1926.1203 requires a written permit documenting hazards, controls, and authorized entrants before entry into a permit-required confined space.

  2. Under OSHA 1926.403, electrical equipment used on construction sites must be listed or labeled by:

    Answer: A nationally recognized testing laboratory (NRTL)

    OSHA requires electrical equipment to be listed by a Nationally Recognized Testing Laboratory such as UL or ETL.

  3. Ground fault circuit interrupters (GFCIs) are required on construction sites for all 120-volt, single-phase, 15- and 20-ampere receptacles. Which OSHA subpart contains this requirement?

    Answer: Subpart K – Electrical

    OSHA Subpart K (1926.404) contains GFCI requirements for temporary power on construction sites.

  4. A construction inspector observes a scaffold plank with a visible crack running along its length. The correct action is to:

    Answer: Tag it out of service and remove it immediately

    Cracked or damaged scaffold planks must be immediately removed from service to prevent catastrophic failure under load.

  5. OSHA's Silica standard for construction (29 CFR 1926.1153) requires medical surveillance for workers exposed above the action level for how many years?

    Answer: 30 years or more

    The silica standard requires medical surveillance when workers are exposed at or above the action level for 30 or more days per year.

  6. Under the OSHA Lockout/Tagout standard (29 CFR 1910.147), which step must occur FIRST in an energy control procedure?

    Answer: Shut down the equipment using normal stopping procedures

    The equipment must first be shut down using its normal stopping procedure before energy isolation devices are applied.

  7. The OSHA multi-employer worksite policy states that a controlling employer is one who:

    Answer: Has general supervisory authority over the worksite

    OSHA's multi-employer citation policy defines the controlling employer as one with general supervisory authority over the worksite.