CA Flagger CA Flagger Equipment and Devices 3

Question 1

What should a flagger do if their STOP/SLOW paddle is damaged or broken during a shift?

Accepted Answer

Use a backup flag and notify the supervisor immediately

Answer

A flagger must switch to the backup flag device and immediately report the damaged equipment to a supervisor.

Question 2

At night or in low-visibility conditions, what additional equipment must flaggers in California use?

Accepted Answer

Illuminated or retroreflective vests and lighted wands or paddles

Answer

Night flagging requires retroreflective or illuminated apparel and lighted paddles or wands so drivers can clearly see the flagger.

Question 3

What is the recommended height for holding a STOP/SLOW paddle so drivers can clearly see it?

Accepted Answer

Above shoulder height with arm extended

Answer

The paddle should be held above shoulder height with the arm extended so it is visible well above the hood line of approaching vehicles.

Question 4

Which of the following best describes a flagger station?

Accepted Answer

The designated location where a flagger stands to control traffic

Answer

A flagger station is the specific, pre-designated position where the flagger stands to direct and control traffic flow.

Question 5

What must a flagger do with their free hand while displaying the SLOW side of the paddle to oncoming traffic?

Accepted Answer

Use a palm-down motion to signal drivers to reduce speed

Answer

While showing SLOW, the flagger uses a downward patting motion with the free hand to reinforce the message to reduce speed.

(CA Flagger) California Flagger Exam Practice Test