Practice Test GeeksC33 - C-33 California Painting Contractor License Practice Test
← All C33 Flashcard Decks

Reading Blueprints and Interpreting Paint Specifications Flashcards

6 cards from real C33 practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 6 Reading Blueprints and Interpreting Paint Specifications flashcards as text

  1. What does the term 'WFT' mean in a coating application specification, and how does it relate to DFT?

    Answer: Wet Film Thickness - the thickness as applied, which shrinks as solvents evaporate to become the DFT

    WFT (Wet Film Thickness) is the thickness immediately after application. As solvents and water evaporate, the film shrinks to the Dry Film Thickness (DFT).

  2. On a blueprint, a painted steel column is labeled '3-CT INT.' What does this abbreviation most likely mean?

    Answer: 3-Coat Intumescent fire protection system

    3-CT INT refers to a 3-Coat Intumescent fire protection system - a common specification for structural steel columns requiring fire-resistance ratings.

  3. A painting specification requires 'Munsell color match to 5Y 8/4.' What information does this notation provide?

    Answer: A precise color description: hue 5Y (yellow), value 8 (lightness), chroma 4 (saturation)

    The Munsell color system uses three attributes: Hue (5Y = yellow), Value (8 = light), and Chroma (4 = moderate saturation).

  4. In specifications, what does 'prime coat to be tinted toward finish color' mean?

    Answer: The primer should be tinted to approximate the topcoat color for better coverage

    Tinting primer toward the finish color improves topcoat coverage by reducing the contrast between primer and finish coat.

  5. What information must a C-33 contractor review in the 'Environmental Requirements' section of a painting specification?

    Answer: Temperature, humidity, and surface condition limits for paint application

    The Environmental Requirements section specifies allowable temperature ranges, humidity limits, wind conditions, and surface conditions required for proper application.

  6. A specification addendum changes the exterior paint from semi-gloss to satin. How should the contractor handle this during bidding?

    Answer: Incorporate the addendum into the bid, noting the revised finish and any cost difference

    Addenda are official modifications that must be acknowledged and incorporated into the bid.