BAT Code Compliance & Standards 2

Question 1

Under USC Model Water Codes, which organization publishes the most widely adopted standards for backflow prevention assembly testing procedures in the US?

Accepted Answer

Foundation for Cross-Connection Control and Hydraulic Research (FCCCHR)

Answer

The USC FCCCHR publishes the Manual of Cross-Connection Control, the most widely referenced standard for backflow prevention testing procedures.

Question 2

Which AWWA standard specifically covers reduced pressure principle backflow prevention assemblies?

Accepted Answer

AWWA C511

Answer

AWWA C511 covers reduced pressure principle backflow prevention assemblies, including design, fabrication, and testing requirements.

Question 3

According to most state plumbing codes, a backflow prevention assembly installed on a high-hazard connection must be tested within how many days of initial installation?

Accepted Answer

30 days

Answer

Most state codes require initial testing within 30 days of installation on high-hazard connections to confirm the assembly is functioning correctly.

Question 4

Which section of the International Plumbing Code (IPC) primarily addresses cross-connection control and backflow prevention requirements?

Accepted Answer

Section 608

Answer

IPC Section 608 addresses protection of potable water supply from contamination, including cross-connection control and backflow prevention device requirements.

Question 5

A tester finds a double check valve assembly installed on a connection supplying a facility that uses toxic chemicals. What code compliance issue does this represent?

Accepted Answer

The DCVA should be replaced with a reduced pressure principle assembly

Answer

A DCVA provides only low-hazard protection; toxic chemical connections require an RP assembly due to the high-hazard classification.

(BAT) Backflow Assembly Tester Certification Practice Test

(BAT) Backflow Assembly Tester Certification Practice Test

BAT Code Compliance & Standards 2