AUDI Tools & Equipment Operation 3

Question 1

Which Audi special tool is required when removing the front crankshaft seal on the 2.0T EA888 engine to prevent camshaft timing chain damage?

Accepted Answer

T10352 crankshaft holding tool

Answer

T10352 holds the crankshaft stationary during front seal removal to prevent the timing chain from jumping a tooth under reaction torque.

Question 2

A technician is bleeding Audi electromechanical brake boosters (iBooster). Which tool is required beyond a standard bleeder?

Accepted Answer

ODIS scan tool to activate the iBooster motor during bleeding

Answer

The iBooster's electric motor must be cycled via ODIS guided functions to fully purge air from the integrated hydraulic circuit during the bleed procedure.

Question 3

What is the correct calibration environment specification for Audi front camera (lane assist) recalibration using a target board?

Accepted Answer

Level floor, minimum 10 m clear area, vehicle at standard ride height

Answer

Camera calibration requires a level floor with sufficient clear distance (typically 10 m) and the vehicle at proper ride height to align the target board correctly.

Question 4

When using a compression tester on an Audi TFSI engine, which condition must be met for an accurate reading?

Accepted Answer

Engine fully warmed, throttle held wide open, all plugs removed

Answer

Compression tests require the engine to be at operating temperature, throttle wide open to allow maximum airflow, and all spark plugs removed for consistent cranking speed.

Question 5

An Audi S4 technician needs to remove the supercharger drive belt without damage. Which tool prevents the supercharger pulley from spinning?

Accepted Answer

Supercharger pulley counterhold tool 3217

Answer

Tool 3217 counterhold the supercharger pulley to allow the center bolt to be loosened without spinning the unit or damaging the lobes.

(AUDI) Audi Certified Mechanic Practice Test

(AUDI) Audi Certified Mechanic Practice Test

AUDI Tools & Equipment Operation 3