AUDI Repair & Maintenance 2

Question 1

When replacing brake fluid on an Audi with an electronic parking brake (EPB), what must be done before compressing the rear caliper pistons?

Accepted Answer

Use an EPB service mode via scan tool to retract the caliper

Answer

Audi EPB calipers require scan tool activation of service/retract mode to electrically retract the piston before brake work.

Question 2

Which Audi-specific tool is required to properly align the front subframe during reassembly after engine removal?

Accepted Answer

T10096 subframe alignment pins

Answer

T10096 alignment pins locate the subframe to the body in the factory position, ensuring correct geometry after reinstallation.

Question 3

An Audi 2.0T TFSI shows excessive oil consumption. After confirming PCV is functional, what is the next most likely cause?

Accepted Answer

Worn piston rings due to ring land carbon buildup

Answer

The EA888 2.0T is known for carbon deposits on the piston ring lands causing ring sticking and oil burn.

Question 4

What is the correct procedure for resetting the service interval indicator on most Audi models after an oil change?

Accepted Answer

Use the MMI menu: Car > Service & Checks > Reset Service

Answer

Audi's MMI-equipped models reset the service reminder via the Car Settings menu under Service & Checks.

Question 5

When performing a timing belt replacement on an Audi 1.8T engine, which component is always recommended to be replaced at the same time?

Accepted Answer

Water pump, tensioner, and idler rollers

Answer

The water pump is driven by the timing belt, and its failure interval matches the belt; replacing it prevents a second teardown.

(AUDI) Audi Certified Mechanic Practice Test