Practice Test Geeks(AUDI) Audi Certified Mechanic Practice Test
← All AUDI Flashcard Decks

Repair & Maintenance Flashcards

7 cards from real AUDI practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Repair & Maintenance flashcards as text

  1. During a DSG (DQ250) 7-speed wet clutch service, what fluid specification must be used?

    Answer: Audi G 052 182 (DSG fluid)

    The DQ250 wet DSG requires Audi G 052 182 A2 fluid; incorrect fluid damages clutch packs and causes shudder.

  2. What is the recommended method for bleeding the cooling system on an Audi with a sealed coolant system after a coolant flush?

    Answer: Use a pressurized cooling system filler and run through bleed cycles with heater on max

    Audi recommends using a pressurized filler tool and running the engine through heat cycles with climate control on max to purge air.

  3. An Audi with adaptive air suspension (air ride) shows the vehicle sitting low on one corner after overnight parking. What is the most likely cause?

    Answer: Leaking air strut bladder or solenoid valve

    A single-corner sag overnight points to an air leak at the strut bladder, air line, or corner solenoid valve rather than a compressor fault.

  4. When replacing spark plugs on an Audi 3.0T TFSI supercharged V6, why must the engine be cold before removal?

    Answer: Hot aluminum cylinder heads can strip threads as plugs are removed

    Audi's aluminum cylinder heads are prone to thread damage if spark plugs are removed while the metal is thermally expanded.

  5. What is the purpose of the 'basic setting' procedure performed on Audi throttle bodies after replacement or cleaning?

    Answer: It relearns the throttle plate's fully closed and fully open stop positions

    The throttle body basic setting teaches the ECU the mechanical stop positions so it can accurately calculate throttle opening percentage.

  6. On Audi quattro models with rear Haldex coupling (FWD-based quattro), how often is the Haldex fluid typically serviced?

    Answer: Every 40,000 miles or 4 years

    Audi recommends Haldex fluid replacement approximately every 40,000 miles to maintain proper clutch pack engagement response.

  7. An Audi A6 C7 3.0 TDI develops blue smoke on startup that clears after warming up. What is the most probable cause?

    Answer: Worn valve stem seals allowing oil to drain into combustion chamber overnight

    Blue smoke on cold startup that clears when warm is the classic symptom of worn valve stem seals allowing oil seepage overnight.