ASE Practice Test (B4: Structural Analysis & Damage Repair) 3

Question 1

Which type of welding is the OEM-approved method for most structural panel replacement in modern collision repair?

Accepted Answer

MIG (GMAW) welding with a properly set welder using the vehicle manufacturer's wire and settings

Answer

Most OEM repair procedures specify MIG (Gas Metal Arc Welding / GMAW) welding for structural panel replacement. It provides the required strength, can be used for plug welds that replicate factory spot welds, and produces less heat distortion than gas welding. OEM procedures specify wire type, diameter, gas mixture, and specific weld settings. Flux-core welding is generally not approved for structural body repairs.

Question 2

A technician is replacing a front rail section using the sectioning method. What is a critical requirement for the location of the sectioning cut?

Accepted Answer

The cut must be located in an area specified by the OEM repair procedure, avoiding high-stress zones and crush zones

Answer

Rail sectioning cuts must be placed only where vehicle manufacturers designate as acceptable cut locations. These areas are selected to avoid engineered crush zones (which must remain intact to absorb future crash energy) and areas of high stress concentration. Cuts made in wrong locations compromise the vehicle's crash safety system. OEM repair procedures or I-CAR training specify the approved cut locations.

Question 3

When performing a sectioning weld on a structural rail using an offset (butt) joint, what is the minimum recommended weld overlap distance?

Accepted Answer

25mm (1 inch) or as specified by the OEM

Answer

OEM sectioning procedures typically require a minimum 25mm (approximately 1 inch) offset/stagger of the cut on each flange, or an offset butt joint, to distribute the weld stress area. Proper overlap and offset ensure that the weld joint does not become a single failure point. Always follow the specific OEM repair procedure dimensions, which may vary by vehicle and rail design.

Question 4

After structural repairs on a vehicle equipped with side-curtain and side-impact airbags, what must the technician verify before closing the repair order?

Accepted Answer

That the airbag deployment light is off and scan for airbag DTCs; verify all sensors and mounting points are restored to spec

Answer

Modern vehicles have numerous airbag sensors mounted in structural panels, pillars, and sills. After structural repair, the technician must verify all sensor mounting locations are restored to exact OEM specifications, perform a scan for airbag system DTCs, and ensure the airbag warning light is extinguished. Improperly mounted sensors or damaged wiring can prevent airbag deployment in a future crash, which is a serious safety liability.

Question 5

Which type of corrosion protection should be applied inside sealed structural cavities after welding?

Accepted Answer

Cavity wax or anti-corrosion compound injected through access holes

Answer

The interior of closed structural sections (box sections, pillars, rails) cannot be accessed after assembly. Factory cavity wax is injected through small holes during manufacturing to prevent internal corrosion. After repair and welding, cavity wax or anti-corrosion compound must be re-applied through access holes to restore this protection. Failure to do so leads to internal corrosion that can compromise structural integrity over time.