← All ASE Flashcard Decks

Electrical and Electronic Systems Flashcards

7 cards from real ASE practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Electrical and Electronic Systems flashcards as text
  1. Two 6-ohm resistors are connected in parallel. What is the total resistance?

    Answer: 3 ohms

    Equal resistors in parallel equal one resistor's value divided by the number of resistors: 6 / 2 = 3 Ω.

  2. Adding another bulb in parallel to an existing lighting circuit causes total circuit current to:

    Answer: Increase

    Each added parallel branch lowers total resistance, so total current increases.

  3. With the engine running and loads off, a typical charging system regulated voltage specification is:

    Answer: 13.5–15.0 volts

    Most charging systems regulate to roughly 13.5–15.0 V depending on temperature and design.

  4. On hybrid and electric vehicles, high-voltage cables are identified by which color?

    Answer: Orange

    Industry standard marks high-voltage cables orange; blue or yellow often indicates intermediate voltage circuits.

  5. Which gloves are appropriate when servicing a hybrid vehicle's high-voltage system?

    Answer: Class 0 insulated rubber gloves rated for 1,000 V with leather protectors

    Class 0 lineman's gloves rated to 1,000 V, worn with leather protectors and inspected before use, are the standard.

  6. What is the best method to locate an intermittent open caused by a chafed wiring harness?

    Answer: Perform a wiggle test while monitoring the circuit

    Flexing the harness while watching a meter or scan data reveals intermittent breaks as they occur.

  7. Why should technicians avoid piercing wire insulation with test probes?

    Answer: It can let moisture in and cause corrosion in the wire

    Insulation holes let in moisture that corrodes the copper and creates future high-resistance faults.