โ† All Airframe Mechanic Certification Flashcard Decks

Aircraft Systems & Components Flashcards

7 cards from real Airframe Mechanic Certification practice questions. Tap to flip, then mark Knew It or Still Learning โ€” missed cards come back until you master them.

Read the first 7 Aircraft Systems & Components flashcards as text
  1. What is the primary purpose of an aircraft's spoiler system?

    Answer: Reduce lift and increase drag during descent

    Spoilers disrupt airflow over the wing to reduce lift and increase drag, allowing steeper descents without increasing airspeed.

  2. Which component in a hydraulic system prevents pressure from exceeding a safe limit?

    Answer: Relief valve

    A relief valve opens automatically when system pressure exceeds a preset limit, routing fluid back to the reservoir.

  3. What type of corrosion forms as a white powdery deposit on aluminum aircraft structures?

    Answer: Oxidation corrosion

    Oxidation corrosion on aluminum produces aluminum oxide, which appears as a white or gray powdery surface deposit.

  4. In a fuel system, what is the function of a boost pump?

    Answer: Maintain positive fuel pressure to the engine-driven pump

    Boost pumps provide positive fuel pressure to prevent cavitation in the engine-driven pump, especially during high-altitude operations.

  5. What is the purpose of a Zerk fitting on an aircraft landing gear component?

    Answer: Provide a grease injection point for lubrication

    A Zerk (grease) fitting allows technicians to inject grease into bearings and joints using a grease gun without disassembly.

  6. Which aircraft wing design feature increases the critical angle of attack before stall?

    Answer: Leading edge slat

    Leading edge slats extend the wing's leading edge, increasing camber and allowing the wing to operate at a higher angle of attack before stalling.

  7. When performing a continuity check on a control cable system, a technician finds an open circuit. What does this most likely indicate?

    Answer: A broken or disconnected cable

    An open circuit in a cable system continuity check indicates the electrical path is broken, most commonly due to a broken or disconnected wire or cable.