Technical Knowledge and Skills Flashcards
7 cards from real AET practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.
Read the first 7 Technical Knowledge and Skills flashcards as text
What is the standard word length for data transmitted on an ARINC 429 data bus?
Answer: 32 bits
ARINC 429 uses a 32-bit word format that includes label, source/destination identifier, data, sign/status matrix, and parity bit fields.
A VOR receiver indicates a 'TO' flag with full left CDI deflection. The aircraft is flying directly TOWARD the station. What is the most likely cause?
Answer: The OBS is set 90° off from the inbound course
A full CDI deflection with a TO flag while flying toward the station indicates the OBS course selector is set approximately 90° off from the actual bearing to the station.
Standard aircraft AC bus voltage and frequency for most commercial transport aircraft is:
Answer: 115V AC at 400 Hz
Most transport-category aircraft use 115V AC at 400 Hz, which allows smaller and lighter transformer and motor designs compared to 60 Hz ground power.
Which component of an ILS system provides lateral course guidance to the runway centerline?
Answer: Localizer transmitter
The localizer transmitter, located beyond the departure end of the runway, radiates two overlapping lobes on 90 Hz and 150 Hz to provide lateral guidance to the runway centerline.
A Mode C transponder reply includes which of the following information?
Answer: Pressure altitude and squawk code
Mode C transponder replies encode the aircraft's pressure altitude (in 100-ft increments) along with the 4-digit squawk code assigned by ATC.
DME (Distance Measuring Equipment) operates on the principle of measuring:
Answer: Round-trip pulse propagation time between aircraft and ground station
DME measures the slant-range distance by timing the round-trip delay between an interrogation pulse sent by the aircraft and the reply pulse from the ground transponder.
When troubleshooting an avionics system using a dual-trace oscilloscope, what is the primary advantage of using the 'chop' mode versus 'alternate' mode at low frequencies?
Answer: Chop mode switches between traces rapidly enough that both appear continuous at low sweep speeds
At low sweep speeds, chop mode rapidly switches between channels many times per sweep so both traces appear solid, whereas alternate mode only updates one trace per sweep causing flicker.