AERA AERA Engine Measurement & Machining Tolerances

Question 1

What instrument is most commonly used to measure cylinder bore diameter to verify it is within AERA tolerance specifications?

Accepted Answer

Bore gauge (cylinder dial bore gauge)

Answer

A cylinder dial bore gauge provides the precise inside diameter measurements needed to compare against AERA tolerance specifications for reboring or honing decisions.

Question 2

According to AERA guidelines, what term describes the maximum allowable variation in a crankshaft's main journal diameter along its length?

Accepted Answer

Taper

Answer

Taper refers to the difference in diameter measured at opposite ends of a journal, and AERA sets maximum taper limits to ensure proper bearing fit and oil film.

Question 3

When measuring crankshaft journal out-of-round (ovality), the measurement is taken at how many positions around the journal?

Accepted Answer

At least two positions 90° apart

Answer

Measuring at two positions 90° apart reveals the maximum and minimum diameters, which when subtracted give the out-of-round value for comparison to AERA limits.

Question 4

Which type of micrometer is specifically designed to measure the inside diameter of a camshaft bearing bore?

Accepted Answer

Inside micrometer (tubular)

Answer

An inside micrometer with tubular extensions can directly measure larger bore diameters like camshaft bores with high precision.

Question 5

AERA recommends measuring cylinder bore diameter at a minimum of how many depths to check for taper?

Accepted Answer

At least two depths — near the top and near the bottom of ring travel

Answer

Measuring near the top and bottom of ring travel identifies taper wear since the cylinder wears most at the top of ring travel.

(AERA) Automotive Engine Rebuilders Association Certification Practice Test

(AERA) Automotive Engine Rebuilders Association Certification Practice Test

AERA AERA Engine Measurement & Machining Tolerances