Practice Test Geeks(AEP) American Electric Power Practice Test
← All AEP Flashcard Decks

Tools & Equipment Operation Flashcards

7 cards from real AEP practice questions. Tap to flip, then mark Knew It or Still Learning — missed cards come back until you master them.

Read the first 7 Tools & Equipment Operation flashcards as text

  1. When using a hydraulic crimping tool on high-voltage cable lugs, what must be verified before each crimp cycle?

    Answer: Hydraulic fluid level and die alignment

    Correct hydraulic fluid level ensures full tonnage is achieved, and die alignment prevents off-center crimps that weaken the connection.

  2. An AEP lineman needs to cut a live secondary conductor using approved insulated tools. Which tool is specifically designed for this task?

    Answer: Insulated bolt cutter

    Insulated bolt cutters rated for the applicable voltage are the correct tool for cutting energized secondary conductors safely.

  3. A hot stick's insulating section must be kept free of contaminants. Which cleaning agent is approved for fiberglass hot sticks?

    Answer: Isopropyl alcohol or approved dielectric cleaner

    Isopropyl alcohol or manufacturer-approved dielectric cleaners remove surface contamination without degrading the fiberglass matrix.

  4. What is the primary function of a load buster tool when used on a distribution system?

    Answer: Safely interrupting energized cutout fuses under load

    A load buster (or load break tool) absorbs the arc energy when opening an energized cutout, preventing damage and injury.

  5. During transformer installation, a come-along (lever hoist) begins to slip under load. The correct immediate action is to:

    Answer: Lower the load, inspect the ratchet mechanism, and replace if worn

    A slipping ratchet indicates wear or damage; continuing to lift risks uncontrolled load release, so the tool must be inspected and replaced.

  6. When setting up a portable generator at an AEP storm restoration site, which grounding step is required before energizing loads?

    Answer: Connect the frame to a driven ground rod

    The generator frame must be bonded to an earth ground rod to provide a safe fault current path and prevent touch voltage hazards.

  7. A dielectric glove that passes an air inflation test but shows a small pinhole when immersed in water should be:

    Answer: Removed from service and destroyed

    Any puncture or pinhole compromises the glove's insulating integrity; it must be removed from service and destroyed to prevent accidental reuse.