Safety Procedures & PPE Flashcards

What is the minimum approach distance (MAD) primarily designed to protect workers from?

Answer: Contact with energized conductors and arc flash hazards

MAD establishes a safe boundary that protects workers from both direct contact with energized conductors and the dangers of arc flash.

When must a worker stop and reassess before continuing a task under AEP's stop-work authority policy?

Answer: When the worker observes an unsafe condition or feels the work is unsafe

AEP's stop-work authority empowers any employee to halt work whenever they observe an unsafe condition or have a concern about safety.

Which type of glove insulation class is rated for up to 17,000 volts AC?

Answer: Class 2

Class 2 rubber insulating gloves are rated for a maximum use voltage of 17,000 volts AC.

Before climbing a wood utility pole, a lineworker should inspect it for:

Answer: Rot, woodpecker holes, and structural soundness

Inspecting for rot, damage, and structural integrity ensures the pole can safely support the worker's weight before climbing.

What does LOTO stand for in AEP safety procedures?

Answer: Lockout/Tagout

LOTO (Lockout/Tagout) is the procedure used to isolate energy sources and prevent accidental re-energization during maintenance.

An arc flash hazard analysis determines which of the following PPE requirements?

Answer: The incident energy level and required arc-rated clothing cal/cm²

Arc flash hazard analysis calculates incident energy at the work location and specifies the minimum arc rating (cal/cm²) for required PPE.

Which of the following describes a 'qualified electrical worker' per OSHA 1910.269?

Answer: A worker trained and experienced to work safely on or near energized electrical equipment

OSHA 1910.269 defines a qualified electrical worker as someone with training and experience to recognize and avoid electrical hazards on utility systems.