ACP iParts and iAssemblies 2

Question 1

What is the key difference between a Standard iPart and a Custom iPart in Autodesk Inventor?

Accepted Answer

Standard iParts restrict all values to the factory table; Custom iParts allow user-defined values for specified parameters at placement

Answer

A Custom iPart designates certain parameters as user-editable at placement time, while a Standard iPart locks all parameter values to those defined in the factory table.

Question 2

In an iAssembly, what is the 'factory file'?

Accepted Answer

The master .iam file that contains the iAssembly table with all member configurations

Answer

The factory file is the master assembly (.iam) that hosts the iAssembly table defining all member configurations from which specific members are derived.

Question 3

Which of the following can be controlled within an iAssembly table?

Accepted Answer

Component suppression states, parameter values, and iProperties

Answer

An iAssembly table can control component suppression states, sub-component parameter values, iProperties, and other configuration-specific data for each member.

Question 4

To edit an existing iPart table after it has been created, which method is correct?

Accepted Answer

Right-click the Table entry in the Model browser and select Edit Table

Answer

Right-clicking the Table node in the Model browser and selecting Edit Table opens the embedded spreadsheet editor for modifying the iPart table.

Question 5

How do you exclude a specific component from appearing in certain iAssembly members?

Accepted Answer

Set the component to Suppressed in the iAssembly table for those member rows

Answer

In the iAssembly table, setting a component's state to Suppressed for specific member rows excludes it from those configurations while keeping it active in others.

ACP Autodesk Inventor

ACP Autodesk Inventor

ACP iParts and iAssemblies 2