ACP Sheet Metal Design 5

Question 1

How can a parts list automatically show the flat blank size of a sheet metal part?

Accepted Answer

Use the Sheet Metal Length and Sheet Metal Width iProperties

Answer

Inventor provides flat pattern extent properties that can be shown in parts lists and title blocks.

Question 2

What sketch profile does Contour Flange need, compared with the Face command?

Accepted Answer

Contour Flange uses an open profile, Face uses a closed profile

Answer

Contour Flange adds thickness to an open profile, and Face extrudes a closed profile to the sheet thickness.

Question 3

What happens to the sharp corners in a Contour Flange sketch?

Accepted Answer

Inventor automatically replaces them with bends using the rule's bend radius

Answer

Contour Flange automatically adds bends at the sketch corners using the active bend radius.

Question 4

Which command explicitly sets the face that controls flat pattern orientation and punch direction?

Accepted Answer

A-Side Definition

Answer

A-Side Definition sets the face Inventor uses as the A side, which controls the punch direction and flat pattern orientation.

Question 5

Your shop gives you measured bend deduction values for each thickness, radius, and angle. Which unfold rule type should you use?

Accepted Answer

Bend Table

Answer

A Bend Table unfold rule looks up measured bend allowance or deduction values from a table.

ACP Autodesk Inventor